How to Move a Hot Tub With a Rented Utility or Flatbed Trailer

Pablo Fernandez
Pablo Fernandez
November 17, 2026
How to Move a Hot Tub With a Rented Utility or Flatbed Trailer

You bought a used hot tub three towns over, or you're taking yours to the new house. It's 7 feet square, weighs as much as an upright piano and the seller's back deck isn't getting any closer to the driveway.

Hot tubs crack when they flex, tip when they're on edge and slide when a strap is in the wrong place. One bad lift costs more than the tub did.

With the right trailer, two or three helpers and straps that protect the shell instead of crushing it, moving a hot tub is a Saturday job. Here's how to move a hot tub on a rented utility or flatbed trailer.

Know the Weight and the Width

A typical four-to-six-person acrylic hot tub weighs roughly 500 to 900 pounds empty, and larger tubs can top 1,000. Full of water, the same tub weighs 3,000 to 6,000 pounds, which is why the first rule is the only rule with no exceptions: drain it completely, including the plumbing lines, before anything else.

Weight isn't the hard part, though. Width is. Most tubs are 7 by 7 to 8 by 8 feet. A utility trailer's deck between the fenders is usually 77 to 83 inches, so a tub won't lie flat on one. A flatbed deck at 96 to 102 inches will take most tubs flat. That single measurement decides which trailer you rent and how you load it. Read more about what the numbers on a trailer listing mean so you can check deck width before you book.

Utility or Flatbed

Flatbed: flat on its base

If you can get the tub up there, a flatbed is the safest way to move one. The tub rides the way it was built to sit, the center of gravity stays low and the four corner tie-down points are exactly where you want them. Read more about what size flatbed trailer you need; a 16-foot deck leaves room for the cover and the steps.

Utility trailer: on its edge

A 6x12 or 7x14 utility trailer with a ramp gate works when the tub stands on edge between the fenders. The trade-off is a tall, narrow load that catches wind, and straps that have to do more of the work. It's a common way to move a tub, but it asks more of you. Read more about what a 6x12 utility trailer can hold and when to size up.

Weight isn't the deciding factor

Either trailer's payload clears a dry hot tub several times over. Pick the trailer by how the tub will sit on it, not by what it weighs. Read more about what GVWR is if you want the math anyway.

Prep the Tub

  • Drain it completely. Open the drain, then blow out or shop-vac the plumbing lines. Water left in the lines adds weight and freezes in winter.
  • Kill the power. Turn off the breaker. If the tub is hardwired at 240 volts, have an electrician disconnect it; that isn't a homeowner job.
  • Remove the cover and anything loose. Cover, steps, loose cabinet panels and the cover lifter travel separately.
  • Photograph everything. Shell, cabinet, lip and plumbing, before it moves.
  • Pad the edges. Moving blankets over the lip and corners, taped to themselves, never to the acrylic.

Get It Onto the Trailer

Why you need helpers

Two people minimum, three or four is better. An 800-pound shell on edge has no handles and no patience, and the moment it starts to go, one person can't stop it. Nobody gets under it, ever.

Tilt it onto skids or dollies

Lift one edge a few inches and slide furniture dollies or 4x4 skids under it, then repeat on the opposite side. Move the tub flat on the dollies as far as you can, across the deck and down the driveway, and only tip it on edge at the last moment if the trailer requires it.

Loading flat on a flatbed

Use the ramps, keep the tub on dollies and have two people pushing and one guiding. A come-along or the trailer's winch, if it has one, takes the strain out of the ramp climb. If anything twists or a dolly wheel drops off the ramp, stop and reset. Don't muscle through it.

Loading on edge in a utility trailer

Lay plywood on the deck to spread the load, put moving blankets on the edge that will carry the weight and walk the tub up the ramp gate on edge with one person on each side and one behind. Stand it against the front rail if the trailer has one, with the heavy equipment-pack side down.

Position it

Centered left to right, weight ahead of the axle and nothing hanging past the deck. A tub that overhangs the side is an illegal load and a tub that overhangs the back is a sail. Read more about flatbed load distribution and the 60/40 rule.

Strap It Like It Wants to Leave

Four ratchet straps minimum, each rated well above its share of the load. Run every strap over a padded edge or a corner protector, never bare webbing on the acrylic lip, because a strap at a single point of contact is how shells crack. Snug the straps, then give each a half-turn more. Do not crank them. Acrylic cracks under point load long before the strap is anywhere near tight.

On a flatbed, one strap over each corner pulling down and in. On edge in a utility trailer, one strap over the top pulling the tub toward the front rail, one around each side pulling toward the deck and a blocking board screwed or wedged at the base so the bottom edge can't walk. Strap the cover separately or put it in the truck; a loose cover is a kite.

Read more about how to tie down an irregular load on an open utility trailer, and about dunnage, corner protectors and edge guards. If you've moved a piano on a trailer, a hot tub follows the same logic; read more about renting a trailer to move a piano safely.

On the Road

A tub on edge is a sail, so a crosswind you'd never notice with an empty trailer will push you around. Drive slower than the limit, watch your height clearance if the tub stands tall and pull over after the first 10 minutes to re-check every strap. Acrylic settles into the blankets and straps go slack. Read more about how to tow a trailer in rain, wind and bad weather.

At the Other End

Reverse the process with the same helpers. Pad the landing surface, get the tub back onto dollies as soon as it's on the ground and roll it to a level, solid pad. Never drag a hot tub into position; the base isn't built for it. Then let the electrician reconnect it before it sees water.

What about insurance and damage protection?

Before towing a rented trailer, contact your auto insurance provider to ask whether your policy covers liability and towing-related damage claims.

Eligible rentals booked through Big Rentals also include Basic Rental Protection at checkout. This added protection can help limit your financial responsibility for certain damage or theft events during the rental period.

For full details on how Basic Rental Protection works, including deductibles, exclusions, and renter responsibilities, review our FAQ and platform terms.

Protection applies to the rented trailer, not to the hot tub riding on it.

Ready to Move It?

Drain it, measure it, pick the trailer by width, bring help and pad every edge the straps touch. Do that and the tub arrives in one piece and so do you. Browse trailer rentals near you.

The Short Version

  • Drain completely, lines included. A full tub weighs 3,000 to 6,000 pounds; an empty one 500 to 900.
  • Width decides the trailer: flat on a 96-to-102-inch flatbed, or on edge in a utility trailer.
  • Kill the breaker and have an electrician handle a hardwired tub.
  • Two helpers minimum, three or four better. Nobody under it.
  • Move it flat on dollies as far as you can; tip it only when the trailer requires it.
  • Four straps over padded edges, snug plus a half-turn, never cranked.
  • Slow in wind, re-check straps after 10 minutes, roll it onto a level pad at the other end.